Folding The Chassis; Locking The Brake - Emmaljunga NXT90 CLASSIC Manual De Instrucciones Y Servicio

Chassis
1) ASSEMBLY OF THE CHASSIS
1.1 Unfolding the Chassis
Release the transport lock by pulling the rear
and front leg firmly apart until you hear a "Click"
WARNING There must not be a child in the pram
when it is folded or unfolded
WARNING Avoid having children in the vicinity
when the pram is folded or unfolded.
WARNING Ensure that children are kept away from
all moving parts of the pram to avoid risk of injury.
1.2 Fold out the rear leg.
1.3 Press the bar in the middle of
the chassis until you hear a clear "click".
Make sure left and right side "Click" in properly.
1.4 Make sure that you now see the closed padlock.
WARNING ALWAYS check before use that the
chassis is locked. The closed padlock will be shown.
1.5 WARNING If the open padlock is visible, the chassis
is NOT locked.
WARNING If the open padlock icon is visible, press
down on the metal bar, the chassis locks and you
will hear 'click'. Never use the stroller if the symbol
with the open padlock is visible.
1.6 Pull out the telescopic handle.
1.7 Lock both grey clips on the right and left of the
handlebars. Make sure that the telescopic
handlebar clips are properly locked with a "click".
Make sure that the handlebar is at the same height
on both sides before you lock into place.
WARNING Ensure that children are kept away from
all moving parts if you adjust the pram to avoid risk
of injury.
1.8 Adjust the handle by pressing the grey buttons on
the inside of the handlebar.
Make sure that they click into position.
WARNING! Ensure that children are kept away from
all moving parts if you adjust the pram to avoid risk
of injury.
2) ASSEMBLY OF THE REAR WHEELS
2.1 Wipe dirt from the axles before you put on the
wheels. Press the button on the rear wheel.
Insert the metal shaft axle in the rear wheel.
Ensure that the shaft clicks into the wheel
WARNING Check that the wheels are firmly fixed
and cannot be pulled off the shaft.
2.2 Push the axle shaft into the chassis.
2.3 Lock the shaft with the grey lock that sits on the
brake bar. The shaft shall click in locked position.
Check that the rear wheel is attached to the chassis
properly by pulling the wheel. Repeat on both sides.
WARNING Check that the wheel is firmly fixed and
can not be pulled from the chassis.
WARNING Avoid driving over sharp objects or
sufaces eg. glass or the tyre can be punctured
3) ASSEMBLY OF THE FRONT WHEELS
3.1 Press in the button on the front section of the pram
and push in the front wheel. Release the button
NXT90 Classic v 1.0
and check that the front wheel is attached to the
chassis properly by pulling the wheel. Repeat on
both sides.
3.2 This is how the chassis should look when fully
assembled. (as illustrated in the picture).

4) FOLDING THE CHASSIS

4.1 Take off the carrycot or the seat unit.
Turn the chassis so that the front wheels are pointing
forward (as illustrated in the picture).
Make sure that the shopping basket is empty before
folding the chassis. Brake the stroller by
pressing the brake pedal all the way down.
WARNING There must not be a child in the pram
when it is folded or unfolded.
WARNING Avoid having children in the vicinity
when the pram is folded or unfolded.
WARNING Ensure that children are kept away from
all moving parts of the pram to avoid risk of injury.
4.2 Adjust the handle in the lowest position.
WARNING Ensure that children are kept away from
all moving parts of the pram to avoid risk of injury.
4.3 Open both clips on the telescopic handle.
WARNING Ensure that children are kept away from
all moving parts of the pram to avoid risk of injury.
4.4 Push the telescopic handle down to the lowest point
4.5-4.6 Slide the grey safety handle all the way to
the side (See arrow 1 located on the safety
handle). Maintain the position and rotate the
safety handle all the way (See arrow 2 located
on the safety handle). Lift the safety handle
firmly upwards and the stroller folds.
WARNING Ensure that children are kept away from
all moving parts of the pram to avoid risk of injury.
4.7 The pram is now folded.
5) REMOVING THE REAR WHEELS
5.1 Release the shafts and wheel by, (1) press down
the grey button and at the same time (2) open the
grey clip. Loosen the shaft by pressing the button
on the rear wheel and pull out the shaft.
5.2 Adjustable suspension. The chassis is equipped
with adjustable suspension Turn to Dynamic for
stiffer suspension. Turn to Comfort for softer
supension.
6) REMOVING THE FRONT WHEELS
6.1 Press the grey button on the front part of the chassis
and pull the front wheel off.

7) LOCKING THE BRAKE

7.1 Brake the stroller by pressing the brake pedal
down.
WARNING Never leave the child unattended in the
pram without engaging the brake
WARNING The brake should always be applied
when you lift your child in or out of the pram.
WARNING Never park the pram on a slope.
EN
33