Publicidad
15. Attach lace to the Click® Reel.
Step 1
Orient the reel so that the foot of the reel aligns with the void in the surface collar opposite of the metal insert.
Then determine which lace hole(s) align with your lace path.
Foot
Metal inert
Foot
Lock pin
Lace path
3 possible lace ports ( A, B, C )
Note: If the lock pin occupies one of the lace holes you need to use, then insert another lock pin in the hole you
are not using, and remove the original lock pin to free up that lace hole.
Step 2
Insert lace through lace exit and out of u-shaped hole in the bottom-center of the reel.
Step 3
Tig an overhand knot at desired length and trim tail.
Step 4
Pull lace to seat knot on the far side of the channel midpoint. Push knot into hole with a flathead screwdriver.
Step 5
Repeat process for the other end of lace. Leave ~5 cm of slack lace in the system. Remove any remaining
lock pins.
Channel Midpoint
15.
Coloque el cordón en el carrete Click®.
Paso 1
Oriente el carrete de manera que el pie del carrete se alinee con el hueco del collarín de la superficie opuesta a la
inserción metálica. A continuación, determine qué orificio(s) de encaje se alinea(n) con su trayectoria de encaje.
Pie
Inerte metálico
Pie
Publicidad
