Charging The Battery, Leds; State Of Charge; Assembling The Lawn Scarifier; Attaching The Handlebar - Stihl RLA 240 Manual De Instrucciones

English
► If material removed from the lawn is to be col‐
lected in the grass catcher box:attach the
grass catcher box,
► If material removed from the lawn is to be
ejected to the rear:detach the grass catcher
box, 7.3.3.
► Set the working depth,
► Check the controls,
► If the steps cannot be performed:do not use
the lawn scarifier and consult a STIHL special‐
ist dealer.
6

Charging the Battery, LEDs

6.1 Charging the Battery
The charging time depends on several factors,
e.g. temperature of the battery or the ambient
temperature. The actual charging time may differ
from the specified charging time. For specified
charging times see www.stihl.com/charging-
times.
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300,
500 chargers.
6.2

State of Charge

1
► Press the button (1).
The LEDs (5) glow green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on the Battery
The LEDs can indicate the battery charge state
or faults.The LEDs can illuminate or flash green
or red.
If the LEDs light up or flash green, the charge
state is being indicated.
► If the LEDs light up or flash red:remedy the
faults, 20.1.
There is a fault in the lawn scarifier or in the
battery.
30
7.3.2.
13.2.
12.1.
80-100%
60-80%
40-60%
20-40%
0-20%
6 Charging the Battery, LEDs
7 Assembling the Lawn
Scarifier
7.1

Attaching the Handlebar

► Switch the lawn scarifier off, pull out the acti‐
vation key and remove the battery.
► Place the lawn scarifier on a level surface.
► Push holder (8) onto bolts (7).
► Align upper handlebar (1) and centre handle‐
bar section (2) so that the bores align.
► Insert bolt (7) and align so that the bolt head is
flush with centre handlebar section (2) on both
sides.
► Place washer (4) on bolt (7).
► Screw on wing nut (3).
► Align lower handlebar (10) and centre handle‐
bar section (2) so that the bores align.
► Insert bolt (7) and align so that the bolt head is
flush with centre handlebar section (2) on both
sides.
► Place washer (4) on bolt (7).
► Screw on wing nut (3).
► Press cable (9) into holders (8).
The handlebar must not be dismantled again.
7.2 Removing the Combing Roller
from the Transport Compart‐
ment Before Use for the First
Time
► Switch the lawn scarifier off, pull out the acti‐
vation key and remove the battery.
► Place the lawn scarifier on a level surface.
► Open quick-clamping devices (1) and fold
down the handlebar to the rear.
0478-670-9809-B