Installation - Agilent Technologies Turbo-V 6000 Manual De Instrucciones

Each controller is factory set for a specific power supply:
Check voltage selector window for correct set and connect power
cord.

Installation

WARNING! The Turbo-V controller is equipped with a 3-wire power cord and plug
(internationally approved) for user safety. Use this power cord and plug in
conjunction with a properly grounded power socket to avoid electrical
shock. High voltage developed in the controller can cause severe injury or
death. Before servicing the unit, disconnect the input power cable.
The Turbo-V controller can be used as a bench unit or a rack module, but it must
NOTE
be positioned so that free air can flow through the holes. Do not install or use
the controller in an environment exposed to atmospheric agents (rain, snow,
ice), dust, aggressive gases, or in explosive environments or those with a high
fire risk.
During operation, the following environmental conditions must be
respected:
To connect the controller to the pump use the specific cable supplied
with the controller.
See the appendix "Technical Information" for detailed Information
about the above mentioned and the other connections, and about the
options installation.
Turbo-V 6000 Controller User Manual / 87-900-855-01 (F)
model 969-9491 is factory set for 220 Vac operation
model 969-9591 is factory set for 120 Vac operation
temperature: from O °C to +40 °C;
relative humidity: 0 - 95% (without condensation).
Instructions for Use

Installation

197/274
16