Safety Instructions - cecotec Ready Warm 8700 Power Steel Manual De Instrucciones

1. SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
• Make sure that the mains voltage matches the voltage sta-
ted on the rating label of the appliance and that the wall
outlet is grounded.
• This appliance is intended for household use only. Do not
use for industrial or commercial purposes.
• Check the power cord regularly for visible damage. If the
cord is damaged, it must be replaced by the official Techni-
cal Support Service of Cecotec in order to avoid any type of
danger.
• Always use it with the fins in horizontal position.
• Do not insert any object between the product's fins to avoid
damage and dangerous situations.
• Do not place the appliance close to heat sources, flammable
substances, wet surfaces where it can fall or be pushed into
water or allow it to come into contact with water or other
liquids.
• Do not attempt to repair the device by yourself, contact the
official Technical Support Service of Cecotec instead.
• Do not place the appliance immediately below a power soc-
ket.
• Always unplug the device when not in use.
• To prevent power overload, do not plug the device into a
socket where there is another product plugged.
• To disconnect the device, first turn all controls off, then re-
move the plug from the power supply. Pull from the plug,
not the cord.
• Ensure the walls where the device is going to be installed
present no damage and that they are in good and safe con-
ditions.
• This heater is not equipped with a device to control the
READY WARM 8700 POWER STEEL
ENGLISH
7