Rear Panel - ION POWER GLOW 300 Guia De Inicio Rapido

Features

Rear Panel

1. Media Panel Buttons: Controls for the
USB/SD, FM radio, and Bluetooth
sources. These
selection and music playback options. See
Media Panel
2. USB Port: Connect your USB flash drive
here to play music. You can also use this
port for charging the USB device.
3. SD Card Slot: Insert your SD card here to
play music.
4. Display: This screen shows information
relevant to Power Glow
operation.
Note: The Display comes with a plastic
protector on it. Remove this for optimal
viewing.
5. Mic Inputs (1/4"/6.35 mm & XLR): Connect a microphone or mic-level source to these
inputs.
6. Aux Inputs (1/8"/3.5 mm / 1/4"/6.35 mm): These stereo inputs can be used to connect
a CD player, MP3 player, or other audio source.
7. RCA Inputs: Connect a CD player, digital media player, mixer, or other media source
to these inputs. Devices connected here will play through the Aux channel in Aux
mode.
8. Mix Out (1/4" / 6.35 mm): Connect this output to a speaker, mixer, or recorder.
9. Control Knob: Turn this knob to adjust the main volume (overall output) of the
loudspeaker. Push this knob to select and make adjustments to the mic volume,
source volume, echo effect, low EQ, and high EQ.
10. Power LED: This LED illuminates when the unit is powered on.
11. Clip LED: The Clip LED will flash red if the signal from the input jacks or media panel
audio source is clipping (distortion from an overly loud signal). If this happens,
decrease the main volume using the Control Knob or the source, or the mic volume (if
a loud device is plugged into either).
12. Light Mode Button: Press this button to toggle between three modes for the lights on
the front panel:
•
Color Cycle: The lights slowly glow and cycle through colors. This is the default
mode when Power Glow
button to freeze the lights on one color. Press and release the button to unfreeze.
•
Beat Sync: The lights flash and change colors according to the tempo of the music
playing on the speaker.
•
Off: The lights turn off.
13. Power Cable Input (IEC): Insert the included power cable here to charge the unit.
14. Power Switch: Toggle this switch to turn Power Glow
controls include
for more information.
™
300's current
™
300 is first powered on. Press and hold the light mode
®
audio
mode
1 1
1 2
™
9
1 6 1 7
1 5
14
300 on or off.
1 4
1 1
12
1 3
11
8
10
13
5