Using The Radio; Connecting Two Speakers - ION POWER GLOW 300 Guia De Inicio Rapido

SD/USB Mode
Press the Mode button to toggle through to select SD or USB mode. Power Glow
will automatically play the first compatible file. Files are played in alphabetical order of
what is on the root level, then alphabetical by folder, and then alphabetical by track name.
Media playback will stop when all media has been played on the SD card or USB drive.
Note: The SD card or USB drive must have playable files for it to appear on the media
panel's display. If there is no USB drive or SD card inserted into the media panel, press
and release the Mode button will toggle through Bluetooth and radio.
Repeat settings (abbreviations will show on the display):
•
ALL: Repeat all of the tracks in the folder.
•
FOLd: Repeat all of the tracks in the folder.
•
OnE: Repeat the current playing USB track.
•
rAn: Shuffle the track order.

Using the Radio

In Radio Mode, press Play/Pause to select a previously saved preset station. To save the
current station as a preset, press and hold Play/Pause, use the Previous/Next buttons to
select which preset you want to save it to, and press Play/Pause again to confirm.

Connecting Two Speakers

To link two Power Glow
1. Plug a 1/4" cable (not included) into the Mix Out located on the rear panel of one
™
Power Glow
connect audio sources such as a Bluetooth device, microphone, or USB flash drive.
2. Plug the other end of the 1/4" cable into the 1/4" Aux Input on the rear panel of your
second Power Glow
any devices connected to the first speaker (the primary).
3. Power on both speakers using their Power Switches.
4. Connect your audio sources to the first speaker (the primary).
5. The volume of the secondary speaker should be set to "18" to match the primary
speaker's volume.
8
™
300 speakers:
300 speaker. This speaker (the primary) is the one to which you will
™
300 speaker. This second speaker will receive the audio from
™
300