Setup - Compex Mini Manual De Instrucciones

EN

SETUP

Remove the 2 devices and accessories from the box. The accessories include electrodes, lead wires
and a USB cable. The USB cable should be used to charge both units.
1. There are two devices included. The device marked "1" on its side is the master device, and the
device marked "2" is the affiliation device. The master device and the affiliation device are paired as
received. Therefore, after turning on the devices, you can use them directly out of the box.
Note: If the devices unpair, you can pair the mother device with the affiliation device manually. Use
a pin to press the PAIR (RESET) hole on the back of the devices. Press and release the reset hole of
the affiliation device first (beeping twice (0.5s per beeping) and the LED lights keep flashing), mean-
ing the affiliation device is ready for pairing; then press and release the reset hole of the mother de-
vice (beeping and flashing once, 0.5s per beeping/flashing) to send the pairing signal to the affiliation
device. When the pairing is successful, the affiliation device will beep once (0.5s per beeping) and its
LED lights becomes steadily on. Pressing the reset hole for more than 2 seconds could unpair the
affiliation device, indicated by the flashing/beeping twice (0.2s per beeping/flashing).
2. Intensity levels +/- can only be increased or decreased via puck 1 (master device).
3. Alternatively, the phone application can automatically pair with the master device and operate it
via Bluetooth. Simultaneously, the master device controls the affiliation device via the radio
frequency. If using one device make sure it is the master device which is marked "1" on its side.
Note: Cannot independently use puck #2
16
PIN HOLE