SPX EF-7701 Manual Del Usuario página 14

STORING THE TRANSMITTER CODE:
How to program the id-code of the transmitter?
1. Unscrew the 4 screws to open the receiver.
2. Push the teach-in button on the receiver until the red LED
lights up.
3. Release the button when the red LED lights up.
4. Turn transmitter ON.
5. Push on any button of the transmitter that is to be used
with the receiver. The ID-code will be programmed into
the receiver, and the red LED will blink three times.
6. Check if the functions are correctly working by pushing
the buttons of the transmitter and check if the relays are
being activated. The green LED will light up if the receiver
receives the signal from the transmitter. When the trans-
mitter is programmed into the receiver, the red LED in the
receiver will blink continuously two times.
STOP INSTRUCTION
The teaching-in procedure can be stopped by pushing the
button in the receiver for 6 seconds.
ERASING THE PROGRAMMED TRANSMITTER
You can erase the programmed ID-code of the transmitter by
pushing the button on the receiver for more than 8 seconds.
6