Troubleshooting; Fault Reference - Dräger Polytron 8100 Instrucciones De Uso

6.3

Troubleshooting

6.3.1

Fault reference

Fault number Cause
#001 Serious instrument fault,
#003 various causes.
#004
#005
#011 - #014
#020 - #024
#043
#060
#067
#002 Serious data error in the instrument,
#025 - #027 various causes.
#030 - #034
#041
#042
#044
#050
#052
#081
#085
#010 4 to 20 mA interface cable not connected.
#045 Instrument not detecting any sensor.
#051 Faulty zero calibration.
#054
#055 Faulty span calibration.
#076 Instrument fault.
#080 - #084
#090 Sensor lock function is activated. A sensor
with a different part number has been
connected.
#105 Instrument fault.
#137 Instrument fault.
®
1 DrägerService is a registered trademark of Dräger.
Dräger Polytron 8100
Remedy
Have the instrument checked by DrägerService
Reset the instrument to factory default settings (see Section 7
on Page 36).
If this fault occurs again:
Have the instrument checked by DrägerService.
Disconnect the power supply, connect the 4 to 20 mA interface
and reconnect the power supply.
If operated as a stand-alone instrument without a central
controller, wire pin 3 to pin 4 (see Section 3.5 on Page 10).
Check connections.
If this fault occurs again:
Have the instrument checked by DrägerService.
Perform zero calibration (see Section 6.2.1 on Page 31).
Perform span calibration (see Section 6.2.2 on Page 31).
Check electrical connections.
If this fault occurs again:
Have the instrument checked by DrägerService.
Use a sensor with the same part number or disable the sensor
lock function (see Section 5.10.3 on Page 27).
Have the instrument checked by DrägerService.
Cycle power.
If this fault occurs again:
Have the instrument checked by DrägerService.
Maintenance
®1
.
33