Safety Information - Style selections 813SLK01V Manual De Instrucciones

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the
product.
WARNING
• Ingestion is not an expected route of exposure during normal use of this product. If ingested,
consult a physician immediately.
• Keep away from fire and heat sources. Cigarette butts should not be left on the floor. High power
electrical appliances, kettle, stove and other high-temperature objects cannot be directly placed on
the floor, which has a certain safety risk.
• It is not recommended to use wax on vinyl planks as this can cause a slip hazard.
• When cutting the flooring, some dust may be produced. Wear protective gloves and dust mask
for protection.
CAUTION
• Do not install on radiant-heated subfloors with the surface temperature over 29℃.
• STYLE SELECTIONS
• Don't install on any area where the flooring will receive long-term exposure to direct sunlight,
such as sunroom.
• It is recommended to maintain the service area with a temperature of 10-35℃, exceeding which
may accelerate the product aging. Do not install on any area where temperature may be lower
than 10℃ or higher than 35℃, such as unheated dwellings(cabins, cottages, three-seasons
rooms, porches, mobile homes or unheated porches.)
• Protect furniture and chair legs with proper cushion or caps. Avoid using latex or rubber
cushions, which may cause discoloration.
• When handling household appliances or heavy furniture, use hard board or backing plate to
protect the floor. This prevents the flooring from scratching and tearing.
• Do not allow pets with unclipped nails to walk on the vinyl floor. It could cause severe scratching
to the surface.
• Protect your floor against burns. Burns from the glowing end of a cigarette, matches, or other
extremely hot items can damage the floors.
• Avoid exposure to direct sunlight for prolonged periods. During peak sunlight hours, the use of
the drapes or blinds is recommended.
• Always check the cartons to assure the pattern number is correct on all cartons to ensure proper
color match.
• Condition all the floorings in the service area between 15 ℃ and 30 ℃ for 24 hours before
installation, during installation and 24 hours after installation. Please note that the cartons should
be laid flat on the subfloor.
• Check all planks before and during installation. Defective planks must never be used.
• To minimize shade variation, mix and install product from several different cartons.
• Leave an expansion joint of minimum 4-5 mm on all sides of the floor, around pipes, thresholds,
under doors and around any fixed or stationary objects (floor vents, kitchen islands, etc).
is designed for interior use only, do not use it outdoors.
TM
4