Preparation; Preparing The Subfloor - Style selections 813SLK01V Manual De Instrucciones

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 5-10 minutes.
Tools Required for Assembly (not included): Chalk, pencil or mark pen, square rule, hand-hold saw,
utility knife, rubber mallet, pull bar, tape measure, spacers, protective gloves.

PREPARING THE SUBFLOOR

• Make sure that the subfloor is clean, dry and stable.
• Make sure that the subfloor is flat within 0.1875" in a 10-foot span. Any large cracks or voids must
be filled in with a suitable patch, underlayment, or embossing leveler.
• Concrete floors
Practice for preparing concrete floors should comply with ASTM F710.
Concrete must be smooth, clean, flat, and free of dust and moisture. Remove all dust, dirt, grease
and adhesive residue. Sweep and vacuum floor thoroughly. Fill all cracks and holes with a suitable
patch, underlayment, or embossing leveler per manufacturer's instructions.
• Wood Floors
Securely nail all loose boards. Scrape, plane or fill uneven boards with a suitable patch,
underlayment, or embossing lever. If the surface is still not smooth, then we recommend installing
a 0.25'' underlayment panel over the wood subfloor.
• Old floor coverings
STYLE SELECTIONS
STYLE SELECTIONS
smooth, dust-free, and the grout lines and any other irregularities are filled with a suitable patch/
underlayment/ embossing leveler.
STYLE SELECTIONS
embossing has been filled in with a suitable patch, underlayment or embossing leveler.
STYLE SELECTIONS
flooring. STYLE SELECTIONS
flooring, to prevent indentation or possible stress on the joints.
It is recommended to remove the existing floor before installing the STYLE SELECTIONS
RFCl's Recommended Work Practices for Removal of Resilient Floor Coverings are a defined set of
instructions addressed to the task of removing all resilient floor covering structures.
may be installed directly over any clean, well-bonded, smooth surface.
TM
may even be installed over ceramic planks as long as the surface is
TM
should not be installed over heavily embossed planks unless the
TM
is unsuitable to install over existing foam-backed or cushion-backed
TM
is not suitable to install over more than one layer of existing
TM
5
.
TM