Product Set Up; Installation Concerns; Product Use; Recline Adjustment - Nuna Myti Manual Del Usuario

Product Set Up

Installation Concerns

DO NOT install this enhanced child restraint on vehicle seats with lab
belts only. (1)
This enhanced child restraint is suitable for vehicle seats with a 3-point
retractor safety belt. (2) If your vehicle has ISOFIX anchor points, we
strongly recommend that you connect the ISOFIX connector to the
ISOFIX anchor points together. (3)
DO NOT install this enhanced child restraint on vehicle seats that face
sideways or rearward with respect to the moving direction of the vehicle.
Please refer to your vehicle owner's manual for recommended or
suggested installation positions. (4)-1
This enhanced child restraint must be installed in the rear vehicle seat.
(4)-2
DO NOT install this on movable vehicle seats during installation.

Product Use

Use Side Impact Shield
1
- This enhanced child restraint is delivered with detachable side impact
shield. This side impact shield must be used on the door side of the
vehicle for best protection. Installation shown in fig. (5)
2
- Press the release button to remove side impact shield. (6)

Recline Adjustment

1
- Squeeze the recline adjustment button (7), to adjust the enhanced child
restraint to the proper position. The recline angles are shown as (8).
2
- There are 3 recline positions for forward facing mode. (8)
Please confirm that the backrest adjustment engaged in place. (9)
The enhanced child restraint may not fit in all approved vehicles when
used in one of these positions.
9
MYTI Instructions

Height Adjustment

for Head Support and Shoulder Harnesses
1
- Please adjust the head support to proper height according to the child's
height. (10)(11)
When used in toddler mode, the shoulder harness height must be even
with child's shoulders. (10) -1
The maximum distance between the shoulder of baby and shoulder hole
is 4 cm. (10) -2
When used in junior mode, the shoulder belt guides must be even with
child's shoulders. (11)
2
- Squeeze the head support adjustment lever, meanwhile pull up or push
down the head support until it snaps into one of the 9 positions. (12)(13)
Before adjusting the head support height have your child lean forward
slightly.
As the head support is adjusted up (from 4th position), the sides of the
child restraint automatically move outward to provide more shoulder
room. (14)
The enhanced child restraint may not fit in all approved vehicles when
used in one of these positions.
Using in the Toddler Mode
(Child height 76cm-105cm/Child weight ≤ 19.5kg/15 months - approx.
4 years old)
1
- If required attach the ISOFIX guides onto the vehicle ISOFIX bars. (15)
Please adjust the seat to the most upright position before assembling
enhanced child restraint.
2
- Open the tether storage cover, and place the top tether behind the vehicle
seat. (16)
3
- Extend the ISOFIX connectors by pressing the release button whilst
pulling on the connector. (17)
There are multiple positions for ISOFIX.
4
- Make sure that both ISOFIX connectors are securely attached to their
ISOFIX anchor points. The colors of the indicators on both ISOFIX
connectors should be completely green. (18)-2
10
MYTI Instructions