Assembly; Right Side; Left Side - Craftsman CMXGVAM1144043 Manual De Instrucciones

NOTE: This unit is shipped without gasoline or oil in the engine. Be certain to service
engine with gasoline and oil as instructed in the Operation section of this manual
before operating your machine.
NOTE: Reference to right and left hand side of the Tiller is observed from the
operating position.
Opening Carton
1. Cut each corner of the carton vertically from top to bottom.
2. Remove all loose parts.
3. Remove loose packing material.
Loose Parts In Carton
• Tiller
• Handlebar Assembly
• Depth Stake Assembly
• Tine Assemblies (4)
• Wheel Assembly
• Engine Oil
• Operator's Manual
• Engine Operator's Manual
Tines
The tines must be installed correctly to insure proper operation. See below for the
proper tine installation:
1. The tines must be installed in the correct location and the correct order. Each
tine is marked as follows:
• A1 — Inner LH Tine
• A2 — Outer LH Tine
• B1 — Inner RH Tine
• B2 — Outer RH Tine
NOTE: Images and descriptions of tine installation are referenced from the FRONT
of the tiller.

ASSEMBLY

2. Use two clevis pins and two cotter pins from the manual bag. From the
FRONT of the tiller install the inner LH tines (A1) onto the inner left side of
the shaft. Install the inner RH tines (B1) onto the inner right side of the shaft.
See Figure 1.

Right Side

B1
3. Use two clevis pins and two cotter pins from the manual bag. From the
FRONT of the tiller install the outer LH tines (A2) onto the outer left side of
the shaft. Install the outer RH tines (B2) onto the outer right side of the shaft.
see figure 3-2.
Right Side
NOTE: The outer tines can be placed in either of the two outside holes. The
inner hole is for a 22" tilling width and the outer hole is for a 24" tilling
width.
6
A1
Figure 1
A2
B2
Figure 2

Left Side

Left Side