Operation - Craftsman CMXGVAM1144043 Manual De Instrucciones

Controls
Now that you have set up your tiller for operation, get acquainted with its controls and
features. These are described on the next two pages and illustrated on this page. This
knowledge will allow you to use your new equipment to its fullest potential.
The operation of any tiller can result in foreign objects being thrown into
the eyes, which can damage your eyes severely. Always wear safety glasses
during operation or while performing any adjustments or repairs.
Recoil starter handle
This handle is used to start the engine.
Engine Controls
See the separate Engine Operator's Manual for information and functions of the
engine controls.
NOTE: This unit was shipped WITHOUT oil in the engine. Oil is included in the
plastic bag packed with the manual in with the unit. Add the oil as directed
in the Gas & Oil Fill Up section. Check the oil level before each operation to
ensure adequate oil is in the engine. For further instructions, refer to the
separate engine operator's manual.

OPERATION

Handle Height
Adjustment
Tines
WARNING
Handle
Depth Stake
Figure 10
Depth stake
The depth stake controls the tilling depth.
Tines
Tilling tines are used to cultivate, furrow and prepare your garden for seeding.
Forward Tine Engagement Lever
The forward tine engagement lever controls the engagement of the tines. Release
the lever to stop the tines.
Handlebar height adjustment
The handle height may be adjusted. Loosen the knob to change the position.
Tighten hardware when complete.
9