Programming; Using The Door Control; To Erase All Codes; 3-Button Remote Controls - Chamberlain Security+ 3000E Manual Del Proprietário

PROGRAMMING

NOTICE: If this Security✚
the receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The
owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code
transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security✚
To Add an Additional Hand-held Remote Control

USING THE DOOR CONTROL

1. Press and hold the button on the
* that you wish to
hand-held remote
operate your garage door.
2. While holding the remote button, press
and hold the LIGHT button on the
door control.
3. Continue holding both buttons while
you press the push bar on the door
control (all three buttons are held).
4. Release buttons when the motor unit
lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.
®
garage door opener is operated with a non-rolling code transmitter, the technical measure in
To Erase All Codes From
Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless entry
you wish to use.

*3-Button Remote Controls

If provided with your garage
door opener, the large button
is factory programmed to
operate it. Additional buttons
on any Security✚ ® 3-Button
remote or mini-remote can
be programmed to operate
other Security✚ ® garage
door openers.
36
® remote controls.