HAMPTON BAY 585-880 Manual De Instrucciones página 3

INSTALLATION INSTRUCTIONS (see diagram):
1. Place fixture on level surface to prevent tip over.
2. Remove the housing cap.
3. Install the GU10 Bulb.
4. Replace the housing cap.
NOTE: Be sure that the housing cap is tight & secure after installing the bulb.
5. Plug the lamp into a 120 volt polarized outlet.
6. Use the switch to turn the unit on/off or dim the light.
CAUTION: As a safety feature, this up-light will automatically shut off when
it is tipped over. When placed back in an upright position on a stable surface,
the fixture will light again.
INSTALLATION INSTRUCTIONS DIAGRAM:
Housing cap
GU10 bulb
Lamp housing
Base
Dimmer switch
3