Fullwat CMF-7C Serie Manual Del Usuario página 10

1. IMPORTANT INFORMATION
Thank you for purchasing our smart battery charger. Please read this instruction manual
carefully before operating the device. Keep this manual in a safe place for future reference.
This instruction manual is part of the product. It must be handed over along with the device if it
is passed on to a third party.
2. INTRODUCTION
This compact smart battery charger uses the latest switch-mode technology and it designed
particularly to charge lead-acid batteries in dual battery system to their best level. The
automatic 7 stage charging algorithm delivers a much faster, efficiency and full charge without
the issue of voltage drops. Thanks to the boost-charging function, which helps to activate the
battery status, a weak or flat battery could be brought to a suitable recharge level. This also
improves the charge delivered to your battery, increasing battery life and saving on premature
battery failure.
This smart battery charger can be used charging for GEL/AGM/WET batteries by press the mode
selection button. It could also be used as a constant voltage power supply to run appliances
that require a stable and clean DC voltage. For safety reasons, the input and output of the
charger are completely isolated and the batteries are protected for overcharged.
The cooling fan is thermal & charge current dual controlled. When temperature reache up to
45ºC or when charge current reache up to 2A, the cooling fan start to working, it will switch on
and off automatically to control the internal temperature of the unit.
Only when this smart battery charger connects battery, the charger has DC output to start
charge.
Note: This is a charger with soft-type paramer selector. Please, touch voltaje selctor to check
starting voltaje in costant current mode is 12.6 Vdc unless.
DC short circuit protection: after short circuit protection, cutoff the DC output, LCD display "-P-",
after short circuit release auto. Reset.
Over heat protection: when temperature up to 75±5ºC, the LCD display "-P-", when
temperature down auto. Reset.
3. WARNING
Risk of electric shock! Do not open the device if it has been connected to the AC power
source.
4.
This device has been CE tested and conforms to the applicable directives and
standards.
- 10 -