Fullwat CMF-7C Serie Manual Del Usuario página 12

6. 7-STAGE AUTOMATIC CHARGING
This is a fully automatic battery charger with 7 charge stages.
Automatic charging protects your battery from being overcharged. So you can leave the
charger connected to the battery indefinitely.
7-stage charging is a very comprehensive and accurate charging process that gives your
battery longer life and better performance compared to using traditional chargers.
7-stage chargers are suitable for most battery types including GEL, AGM, WET batteries. They
may also help restore drained and sulphated batteries.
THE 7 STAGES ARE:
Desulphatlon: Desulfation: The desulfation stage may break down the sulfation that occurs
in batteries that have been left flat for extended periods of time, returning them back to full
charge. Sulfation occurs when lead-sulphate hardens and clogs up to battery cells.
Soft start: A preliminary charge processes that gently introduces power to the battery. this
protects the battery and increase battery life.
Bulk charge: Charging with maximum current until approximately 80% battery capacity.
Absorption: Charging with declining current to maximize up to 100% battery capacity.
Battery test: Tests the battery whether can save power. If unable, battery may need replacing.
Recondition: Choose the recondition program to add the recondition stage to the charging
process. During the recondition stage voltage increases to create controlled gassing in the
battery. Gassing mixes the battery acid and gives back energy to the battery.
Float: the float stage maintains the battery at 100% charge without overcharging or damaging
the battery. This means the charger can be left connected to the battery indefinitely.
The battery charger has an 7-stage fully automatic charging curve, the cycle is repeated
infinitely. If the terminal voltage drops below a lower limit, the charger automatically goes back
to the beginning of the charging curve.
7. CAUTION!
• The device is for indoor use, do not use the device near flammable materials or in any
location that may accumulate flammable fumes or gasses.
• Appliance shall only be used with rated voltage and frequency.
• Hot surface when operating, especially at full load condition.
• Make sure the polarity is correct.
• Do not locate the device on the top of the battery. Especially wet type battery. it may
generate gas while charging.
• Do not charge non-rechargeable batteries.
• Use the appliance only in the described manner.
• Do not expose the device to a heat source, such as direct sunlight or heating.
• Store the device in a dry and cool place.
• Do not open. No user serviceable parts inside.
- 12 -