Publicidad
Idiomas disponibles
Idiomas disponibles
2. Place the battery pack of the ReadyHedger
in Figure 1. A RED LED should illuminate which shows the battery pack is
properly aligned in the charger.
3. The battery should reach a full charge in approximately one-hour. At this point
the GREEN LED will replace the RED LED.
4. It is normal for the battery pack and/or charger to feel warm to the touch while
charging.
Charging Notes:
• CAUTION: The charger can only be used with 60 cycle, 120 VAC electricity.
• ONLY charge the battery pack with the charger provided.
• SAFE CHARGE –The battery pack can be left on the charger indefinitely.
• Longest life and best performance will be obtained when charging at normal
room temperature.
• Battery life is dependent on usage, storage temperature and time.
Before operating, Insert fully charged battery as illustrated in Figure 2.
®
into the charge cradle as illustrated
Figure-1
Figure-2
5
To turn tool ON, slide the thumb switch on top of the handle FORWARD. While
holding thumb switch FORWARD, squeeze the trigger switch (under the handle) to
start the unit. See Figure 3. NOTE: Release the SAFETY thumb switch once the
unit is running.
To turn tool OFF, merely release the trigger switch. The thumb switch will snap
backward to prevent the trigger switch from being accidentally depressed.
TRIMMING TECHNIQUES
Maintain proper balance at all times. Keep hands away from blades. Wear eye
protection when using the unit. Hold the trimmer firmly with both hands and turn
ON. See Figure.
• The trimmer works best with dry hedges and bushes but it can be used safely
with wet growth due to the low voltage design.
• A wide sweeping cutting motion away from the body is recommended, and will
get the greatest amount of trimming per charge.
• When cutting below your waste (around small bushes or on the side of bushes)
be particularly careful to avoid hitting your legs and feet.
Figure-3
Figure-4
6
Publicidad
