Publicidad
Idiomas disponibles
Idiomas disponibles
•
Inspect the connection between the battery pack and the charge cradle. The
RED LED should illuminate when a normal temperature discharged battery
pack is placed in the charger.
•
Inspect charger to make sure it is correctly plugged into a working outlet. Many
outdoor or garage outlets in newer homes are protected by ground fault (GFCI)
circuits to prevent electrical shock from moisture. Make sure the charger is
completely plugged into wall outlet and that the outlet is in working condition
(i.e. not temporarily disabled by a GFCI protector).
•
The LED on the unit's charger should turn green after approximately 1
hour of charging during regular use and up to 2 hours during its initial or
after long periods of non-use (i.e. over the winter months).
Problem: GREEN LED immediately illuminates when trying to charge a spent
battery.
Solution(s): Battery pack can become hot after long use. Allow battery pack to
reach normal temperature (between 50-100 degrees Fahrenheit) before attempting
to charge. It is okay to leave battery pack in charger while it is cooling down to a
normal temperature. When the battery temperature reaches the correct level the
charger will recognize it and charge it.
Problem: Cutting or run-time performance is diminished.
Solution(s):
•
Please follow the trimming techniques described in this manual for best per-
formance.
•
®
The ReadyHedger
should operate for approximately 40 minutes under a full
charge. If your run-time is considerably less than this, disconnect the battery
pack and inspect the blades to be clean and free of obstruction(s)
•
Make sure the unit is fully charged – see the Operations section of this manual
for charging details.
Problem: Thumb safety switch is difficult to hold on during use.
Solution: The thumb safety switch need only be engaged when starting the unit.
There is no need to keep switch in forward position while using the product.
Problem: Unit will not operate .
Solution: Check to see that battery pack is properly installed.
9
ANTES DE DEVOLVER ESTE PRODUCTO POR
CUALQUIER RAZÓN, POR FAVOR LLAME AL
1-800-637-2867.
CONSEJOS IMPORTANTES:
• La unidad viene completamente armada. Quite la
cubierta plástica antes de usarla, luego úsela para
cubrir la cuchilla cuando no use la unidad.
• Debe cargar la batería antes de usar el aparato. Por
favor remítase a las instrucciones de carga.
• Cuando encienda la unidad, debe primero empujar
el seguro hacia el frente y luego presionar el gatillo
(vea la Figura). No es necesario mantener el
seguro presionado durante el uso.
• Si la cuchilla se encaja en una rama mientras corta,
INMEDIATAMENTE suelte el gatillo y quite la
obstrucción (vea la página 5 de las instrucciones).
Si mantiene el gatillo presionado mientras la
cuchilla esté obstruida, dañará el motor.
• IMPORTANTE: esta herramienta es poderosa e
increíblemente cómoda de usar. Por lo tanto, por
favor preste atención a la posición de las cuchillas
mientras la use para evitar daño corporal.
PRECAUCIÓN:
Lea el manual antes de usar el producto y siga las reglas
de seguridad y las instrucciones de funcionamiento.
10
Publicidad
