Front And Rear Panels; Front Panel - IVIEW K Serie Manual Del Usuario

2. FRONT AND REAR PANELS

2.1 Front Panel

1) LED Indication
The following LEDs will be on when:
: Power is connected
: HDD is reading or recording / HDD Full: HDD is full
: Any event alarm is triggered
: Timer recording is activated
Note: To turn off your DVR, please disconnect the power supply.
2) (USB port)
To quickly backup or upgrade firmware/OSD, you can insert a compatible USB flash drive into this USB port.
Before using the USB flash drive, please use your PC to format the USB flash drive as "FAT32" first.
Note: For the list of compatible USB flash drives, please refer to "APPENDIX 2 COMPATIBLE USB FLASH
DRIVE BRAND" at page 63.
3) IR receiving zone
If the control panel is removed from the DVR and used as a remote controller, aim the remote controller at this
area (near the USB port) to control the DVR operation.
4) (Lock mode) /
To lock the remote controller back to the DVR, switch the lock button to the left "
To remove the control panel from the DVR and use as a remote controller, switch the lock button to the right "
(unlock mode).
Note: Selected Models Only
A vertical panel sticker may be supplied within the sale package. This sticker is used when the DVR
front panel is removed from the DVR and used as a remote controller. Please place it on the
controller for operation convenience.
5) (Menu)
Press to enter / exit the quick start menu.
In the sub-layer of the advanced setting menu,
press to confirm the settings and go back to the upper layer.
6) LIVE
Press to stop the playback and return to the live mode.
7) Channel Display Selection
‧ 16CH DVR with VGA interface built-in
0 ~ 9
Under the live or playback mode, press the channel number you want for channel switch.
‧ 16CH DVR without VGA interface built-in
/ / /
Under the live or playback mode, press one of these four buttons to select the quad display mode.
All manuals and user guides at all-guides.com
(Unlock mode)
(Quad selection mode)
-4-
FRONT AND REAR PANELS
" (lock mode).
"