Technical Data; Eu Declaration Of Conformity - Atlas Copco Power Focus 6000 LV IF Información Sobre Seguridad

Power Focus 6000 LV IF

Technical Data

Technical Data
Power supply
Line voltage (V)
Power rating (W)
Operating temperature
Celsius
Max operating +50°
temperature
Min operating tem- +5°
perature
Weight
Weight (kg)
Weight (lb)
Normal Environmental Conditions
This product is designed to be safe under the following
conditions:
• Indoor use
• Altitude up to 2 000 m
• Operating temperature +5 °C / +41 °F to +50 °C / +122
°F
• Storage temperature +5 °C / +41 °F to +50 °C / +122 °F
• Maximum relative humidity 80 % for temperatures up to
31 °C / 89 °F decreasing linearly to 50 % relative humid-
ity at 40 °C / 104 °F
• Mains supply voltage fluctuations up to ±10 % of the
nominal voltage
• Transient overvoltages up to the levels of overvoltage
category II
• Temporary overvoltages occurring on the mains supply
• Pollution degree 2
• Ingress protection rating: -
Declarations
General Data Protection Regulation
(GDPR)
This product offers the possibility to process personal identi-
fiable information such as system user name, role and IP-ad-
dress. The purpose of this processing capability could be to
enhance quality control through traceability and proper ac-
cess management.
100-240 V
a.c. (50-60 Hz)
1300 W
Fahrenheit
+122°
+41°
10.8 kg
23.8 lb
© Atlas Copco Industrial Technique AB - 9846 0071 00
If you decide to process personal data you need to be aware
of and comply with relevant personal data protection rules,
including, in the EU the GDPR as well as other applicable
laws, directives and regulations. Atlas Copco can in no way
be held liable for any use made by you of the product.
Liability
Many events in the operating environment may affect the
tightening process and shall require a validation of results. In
compliance with applicable standards and/or regulations, we
hereby require you to check the installed torque and rota-
tional direction after any event that can influence the tighten-
ing result. Examples of such events include but are not lim-
ited to:
• initial installation of the tooling system
• change of part batch, bolt, screw batch, tool, software,
configuration or environment
• change of air- or electrical connections
• change in line ergonomics, process, quality procedures
or practices
• changing of operator
• any other change that influences the result of the tighten-
ing process
The check should:
• Ensure that the joint conditions have not changed due to
events of influence.
• Be done after initial installation, maintenance or repair
of the equipment.
• Occur at least once per shift or at another suitable fre-
quency.

EU DECLARATION OF CONFORMITY

We, Atlas Copco Industrial Technique AB, SE-105 23
STOCKHOLM SWEDEN, declare under our sole responsi-
bility that the product (with name, type and serial number,
see front page) is in conformity with the following Direc-
tive(s):
2011/65/EU (RoHS), 2014/30/EU (EMC), 2014/35/EU
(LVD), 2015/863/EU (RoHS amendment)
Harmonized standards applied:
EN 300440 V2.1.1, EN 61010-1:2010, EN
61010-2-201:2013, EN 61326-1:2013
Authorities can request relevant technical information from:
Product Compliance Manager, Atlas Copco Industrial Tech-
nique AB, SE-105 23 Stockholm Sweden
Stockholm, 1 December 2021
Carl von Schantz, Managing Director
Signature of issuer
Safety Information
3