Sony AIWA CDC-R937 Instrucciones De Manejo página 6

Using preset stations
You must preset stations before you can tune in to a
station using preset station number buttons.
r/t SRC(SOURCE)
Preset station
TU(TUNER)
buttons 1 – 6
Presetting stations automatically
(Auto Memory)
1
Press TU (TUNER) repeatedly to select the desired
band ( , ,
2
Press and hold PS/A.ME until automatic presetting
starts. "A MEM" appears on the display.
The unit automatically stores up to 6 stations for
each band.
After completion of automatic presetting, the unit
tunes in to all the stations stored on the preset
station buttons in order (Preset Scan).
To cancel automatic presetting, press PS/A.ME again.
Checking the preset stations (Preset Scan)
1
Press PS/A.ME briefly.
Each preset station will be tuned in for 5 seconds in
order.
To cancel Preset Scan, press PS/A.ME again or any
preset station button.
Presetting stations manually
(Manual Memory)
1
Press TU (TUNER) repeatedly to select the desired
band ( , ,
2
Press t or r to tune in to a desired station (see
"Tuning in to a station," page 4).
3
Press and hold the desired preset station button until
the unit beeps.
Note
A newly preset station replaces the station on the same
band that was previously stored on that preset station
button.
5
ENGLISH
PS/A.ME
Preset station number
, or ).
, or ).
Tuning in to a preset station
1
Press TU (TUNER) repeatedly to select the desired
band ( , ,
2
Press the preset station button on which the desired
station is stored.
Active tuning reception control (ATRC)
The unit automatically suppresses FM noise caused by
vehicle movement, and maintains sound quality.
Radio data system (RDS) features
The following RDS features are available with this unit.
Important
• The RDS features are available only during FM
reception.
• You may not be able to activate the RDS features fully
in the areas where the station is test-broadcasting the
RDS signals.
+ / –
SRC(SOURCE)
Preset station buttons
S(SEL)
1 – 6
Tuning in to Alternative Frequency (AF)
stations
There are programs transmitted at different frequencies
in different areas. Along with the program itself, a RDS
station sends the AF list data that contains the frequencies
sending the same program. If the signal of the tuned-in
frequency becomes weak while you are driving, the unit
automatically searches the same program sent at another
stronger frequency according to the AF list, so that you
do not have to seek and tune in to the other frequency
again.
1
Press AF during FM reception to activate AF function.
"AF" appears on the display.*
* "AF" flashes when the unit cannot receive AF list
data.
, or ).
TA AF
PS/A.ME