Trust START ACDB-7000BC Manual Del Usuario página 11

ACDB-7000BC WIRELESS DOORBELL CHIME WITH BUILD-IN TRANSMITTER
11. Assign transmitter code
While the learn-mode is active, send an ON-signal with any transmitter to assign the code to the
receiver's memory.
12. Code confirmation
The LED indicator will blink fast to confirm the code has been received. The receiver can store up to
4 different transmission codes in its memory. The memory will be preserved when the receiver is
moved to another socket or in case of power failure.
13. Affix transmitter with double-sided tape
Apply double-sided tape to the back of the wireless switch and stick the push button on to a flat
surface.
14. Affix transmitter with screws
Use screws to affix the back plate to a flat surface.
15. Close transmitter
Click both sides of the transmitter on each other.
16. Single code delete
1. Press the [LEARN] button for 1 seconds to activate the learn-mode.
The learn-mode will be active for 15 seconds.
2. While the learn-mode is active, send an OFF-signal to delete the code of a specific
Trust SmartHome transmitter.
3. The LED indicator will blink fast shortly to confirm code deletion.
17. Full memory delete
1. Press and hold the [LEARN] button for 7 seconds until the LED indicator starts blinking fast.
The delete mode will be active for 15 seconds.
2. While the delete mode is active, press the [LEARN] button again for 1 second.
3. The LED indicator will blink fast shortly to confirm memory deletion.
EN
2