Aligning The Appliance In The Installation Enclosure - Bosch B36BT830NS Instrucciones De Instalación

1. Aligning the appliance in the
installation enclosure
Note:

To ensure that the appliance functions correctly,
it must be set perfectly levelled.

Do not twist or jam th e appliance inside the
installation enclosure! When adjusting the height-
adjustable feet, proceed gradually: Always alternat
between left and right, etc.

For easier adjustment of the rear feet take the wei
off by slightly tilting the appliance forward.

Do not bend the appliance against the anti-tip-
brackets.
1. Align the appliance wi th the cabinet fronts.
The height-adjustable feet at the front and rear ca
adjusted from the front.
with open-ended wrench 1 / 2 "
Front:
(Width across flats 13 mm)
with 5 / 16 " (8 mm) hex nut driver via flexible
Rear:
shaft.
All manuals and user guides at all-guides.com
The mark (a) attached at the appliance base is used
a standard gage for height
the height, align this mark at a height of 1
above the floor. It is very im portant to comply with this
dimension for the subsequent alignment of the furni
fronts.
e
2.
ght
3.
n all be
adjustment. When adjusting
The height adjustment gauge (b) is used
to set this height correctly. The upper
edge of the gauge must be in alignment
with the mark on the appliance.
Unscrew the feet at the front of the appliance
until the mark (a) on the appliance is in alignment
with the upper edge of the height adjustment
gauge (b).
Align the appliance vertically using the feet
at the back. Use a level!
as
1 /
2 " (32 mm)
ture
19