Release Pedal Replacement, Foot End; Release Pedal Rod Removal, Foot End - Stryker 1089 Manual De Mantenimiento

RELEASE PEDAL REPLACEMENT, FOOT END

English
Tools Required:
• Needle Nose Pliers
Procedure:
1 . Apply the stretcher brakes .
2 . Disconnect the release pedal return springs from the foot end release pedals .
3 . Remove the rue ring cotters and the clevis pins that connect the foot end release pedals to the mounting bracket .
4 . Rotate the pedals upward .
5 . Remove the rue ring cotters that connect the head end and foot end release rods to the foot end release pedals
and remove the pedals .
6 . Reverse steps to install the new pedals .
7 . Verify proper operation of the unit before returning it to service .

RELEASE PEDAL ROD REMOVAL, FOOT END

Tools Required:
• Needle Nose Pliers
Procedure:
1 . Remove the foot end release pedal . See "Release Pedal Replacement, Foot End" on
2 . Remove the snap in nyliners that hold the foot end pedal release rods into the pedal mounting bracket .
3 . Unsnap the foot end pedal release rods from the white plastic release rod brackets .
4 . Dislodge the side control release pedal swivels from the studs on the side control release pedal weldment .
5 . Remove the foot end pedal release rods .
6 . Reverse steps to reinstall the pedal rods .
7 . Verify proper operation of the unit before returning it to service .
Return To Table of Contents
1-28
Service Information
1089-009-006 REV G
page 1-28 .
www.stryker.com