Saber R50SB0412 Armado Del Asador Y Guía Del Producto página 11

INSTALLATION CON'T.
2. Electronic Ignition Module.
NOTE: A licensed electrician should be used to install the ignition module and make any
wiring extensions or modifications.
This grill has been supplied with enough wire to mount the ignition module in the location shown in Figure 1. The ignition module
can be mounted in a different location by extending the switch wires and ignitor wires. Wire extensions are not provided and
should be made of materials with equivalent ratings as the switch and ignitor wiring provided with this grill (see rating printed on
each wire). If extending the wires, take care to maintain the factory-provided connections that connect the wires to the other grill
components. The ignition module must be mounted so as to have easy access to the battery compartment for battery
replacement. See Figure 2. Connect wires to the small and large connections on the rear of the ignition module. See Figure 3.
2.00"
2.00"
3 Small
Connectors
All manuals and user guides at all-guides.com
Portion of Grill Shown
for Illustration Only
Ignition Module
& Heat Shield
Figure 1
2 Large Connectors
R50SB0412
Rotate cap counterclockwise
to open battery compartment.
Figure 2
4 Small
Connectors
Figure 3
2 Large Connectors
R67SB0312
11