Step 14
Slide seven DIVIDERS (89M) onto the RACK MOLDING (S) so the holes in the DIVIDERS line up with the holes in the
å
RACK MOLDING.
NOTE: The DIVIDERS (89M) should all face the same direction.
å
Fasten these seven DIVIDERS (89M) to the RACK MOLDING (S). Use fourteen BLACK 1-3/8" PAN HEAD SCREWS (118S).
å
Insert the RACK MOLDING (S) into the DIVIDER (89M) on the LEFT END (B) and position as shown.
å
89M
Page 18
89M
S
Unfi nished edge
B
89M
S
419440
89M
118S
BLACK 1-3/8" PAN HEAD SCREW
(14 used in this step)
www.sauder.com/services