Publicidad
Step 18
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw is against
å
the stops as shown in the right diagram. If it isn't, loosen the mounting screw to
slide it against the stops. Then tighten the mounting screw.
Fasten the LEFT DOOR (I) to the LEFT END (B) as shown in the lower diagram.
å
Use the screws in the HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Repeat this step for the other DOORS (H, P, and Q).
å
See the next step for DOOR adjustments.
å
Fasten the DOOR MOLDINGS (T) to the SMALL DOORS (P and Q).
å
Use four SILVER 7/8" PAN HEAD SCREWS (22S).
Fasten a STRIKE PLATE (6I) to the LEFT DOOR (I). Use one
å
BLACK 1/2" FLAT HEAD SCREW (11S).
Insert the DOOR STOP (4I) into the hole in the SHELF (E)
å
exactly as shown.
11S
BLACK 1/2" FLAT HEAD SCREW
(1 used for the STRIKE PLATE)
Page 22
6I
4I
22S
SILVER 7/8" PAN HEAD SCREW
(4 used for the DOOR MOLDING)
I
T
Q
419440
Hinge
C
B
E
D
P
T
www.sauder.com/services
Stop
Mounting
screw
Publicidad
