Greenlee Pull Assist Manual De Instrucciones página 12

9. Install the Pull Assist mounting bar to the puller
where the adjustable sheave bar was using the
quick release pins to secure.
10. Wrap puller capstan according to your puller's
instruction manual and slide the Pull Assist on the
mounting bar so the tail of the rope can enter the
V-Pulley straight. Rope entering the V-Pulley at an
angle increases the risk of the rope slipping out of
the pulley.
11. Lift the rope retention lever and lay the rope in the
V-Pulley. (Fig. 2) Release the rope retention lever
so the rope hangs toward the floor. Avoid tugging
on the rope as it exits the Pull Assist, this action
increases the risk of the rope getting stuck in
V-Pulley.
11. Plug the puller's foot switch into the Pull Assist's foot
switch jack below the rope extraction guide. (Fig.3)
Figure 3
12. Plug in the puller patch cord to the puller's foot
switch jack (Fig. 4).
Figure 4
12
Figure 2
© 2021 Greenlee Tools, Inc.
13. Plug the pendant into the pendant jack (Fig. 5).
Figure 5
14. Plug the puller's power cord into the Pull Assist's
AC outlet and plug the Pull Assist's power cord into
the wall. (Fig.6) You can also plug the puller into a
second wall outlet if one is available
15. Reposition or retain cords to prevent them
becoming entangled with the rope during operation.
16. Turn ON the puller and Pull Assist.
Pull Assist
Figure 6
52093315 REV 0