Maintenance - Greenlee Pull Assist Manual De Instrucciones

Maintenance

• Do not perform any maintenance other than
as described in this manual. Personal injury or
damage to the tool may result.
• Do not modify this tool. Modifying the tool in any
manner may result in personal injury and damage
to the tool.
• Do not attempt to open the tool. It contains no
user-serviceable parts.
Cleaning
Do not use alcohol or other solvents to clean the device.
Wipe the device with a damp cloth with water. Allow to
dry completely before using.
Replace the V-Pulley
If the rope starts to slip and the teeth inside the V-Pulley
show visual signs of wear, such as being rounded off and
shiny, this indicates the pulley needs to be replaced.
1. Unplug the Pull Assist before touching the rope and
V-Pulley. Fingers can be injured if the V-Pulley starts
while maintenance is being performed.
2. Lift the rope retention lever and remove any rope
from V-Pulley.
3. Remove the rope extraction guide by removing the
two bolts securing it to the frame. (Fig.8)
Figure 8
4. Unscrew the V-Pulley by rotating the outer half
clockwise with a 1.25" spanner wrench and
7/32" studs. Once the V-Pulley is loose, continue
unscrewing and slip both halves off the drive shaft.
(Fig. 9) The V-Pulley has a left-handed thread.
52093315 REV 0
5. Slide on the unthreaded half of the new V-Pulley, then
slide on the threaded half and tighten it by rotating
counterclockwise. Before the final few rotations of
the threaded side, adjust the unthreaded half so the
grooves accept the bumps from the threaded half to
sit flush. (Fig. 10) Tighten until secure.
CAT #
RGPAVP
RGPABD
RGPAP
RGPADT
RGPACC
RGPARS
RGPARR
RGPAF
© 2021 Greenlee Tools, Inc.
Pull Assist
Figure 9
Figure 10
Pull Assist Repair Kits
Description
V-Pulley KIT GPA
BOARDS KIT GPA
PENDANT KIT GPA
DRIVETRAIN KIT GPA
PULLER CONTROL CORD KIT GPA
ROPE SYRINGE KIT GPA
ROPE RETENTION KIT GPA
FUSE KIT GPA
15