Tabla de contenido
Publicidad
Control Panel
1
Timer button
2
Inner drying button
3
Fan speed button
4
Tank full indicator
Functions
On/off:
Please plug in the unit.
•
Please make sure that the water tank is empty before switching on.
•
Please press the On/Off button (8) to switch the unit on or off.
•
•
The unit starts automatically with the previous setting.
Mode:
After switching on the unit, please press the mode button (7) to select between automatic and
•
continuous dehumidification. The corresponding indication light lights up.
Automatic dehumidification:
Please press the mode button (7) to switch on the automatic dehumidification function; the
•
corresponding indicator lights up.
The desired humidity level can be set between 30% and 80% in 5% steps by pressing the
•
humidity level button (6).
•
Press the fan speed button (3) to select between high and low wind speed.
•
If the ambient humidity is 5% lower than the set humidity level, only the fan function will be
activated. As soon as the room humidity gets 5% higher than the set value, the compressor will
start automatically.
Continuous dehumidification:
Please press the mode button (7) to switch on the continuous dehumidification function. This
•
mode can be used without regard to the ambient humidity level. To select between high and low
fan speed, please press the fan speed button (3). The humidity level cannot be set in this mode.
Internal drying:
Please press the internal drying button (2) to activate this function. The drying process takes about
•
one hour and prevents the growth of mold.
To stop the drying process, please press the button (2) again. The unit will automatically get back
•
to the operation with previous settings.
To stop the internal drying and switch the unit into stand-by mode, please press the On/Off button.
•
5
LED display
6
Humidity level button
7
Mode button
8
On/Off button
Publicidad
Tabla de contenido
Solución de problemas
