Tabla de contenido
Publicidad
Step 9 - Connect Hose & Regulator to Cylinder
NOTE: You must provide Propane/Butane/LPG cylinder. The pressure of regulator and hose
assembly supplied with the appliance must be used. A dented, rusted or damaged cylinder may be
hazardous and should be checked by your cylinder supplier. Never use a cylinder with a damaged
valve connection. Never connect an unregulated cylinder to the heater.
Lift Cylinder Housing.
•
Screw regulator onto gas hose.
•
Do not cross-thread.
•
Tighten securely.
Attach regulator to cylinder.
•
•
Complete attachment.
Install cylinder.
•
PROBLEMS CHECK LIST
Problems
Pilot will not light
Pilot will not stay on
Burner will not light
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Probable Causes
Gas valve may be OFF
Tank fuel empty
Opening blocked
Air in supply system
Loose connection
Debris around pilot
Loose connections
Thermocouple bad
Gas leak in line
Lack of fuel pressure (tank near empty)
Pressure is low (tank near empty)
Opening blocked
Control not on
Thermocouple bad
Pilot light assembly bent
Not in correct location
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Solutions
Turn the gas valve ON
Refill LPG tank
Clean or replace opening
Purge air from lines
Check all fittings
Clean dirty area
Tighten connections
Replace thermocouple
Check connections
Refill LPG tank
Refill LPG tank
Remove and clean
Turn valve to ON
Replace thermocouple
Place pilot properly
Position properly and retry
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
