Troubleshooting; Front Panel Power Indicator Is Not Lit; No Sound; Protection Indicator Is Lit - Rotel RB-1562 Manual De Instrucciones

English

Troubleshooting

Most diffi culties in audio systems are the result of poor or wrong
connections, or improper control settings. If you encounter problems,
isolate the area of the diffi culty, check the control settings, determine
the cause of the fault and make the necessary changes. If you are
unable to get sound from your amplifi er, refer to the suggestions for the
following conditions:

Front Panel Power Indicator Is Not Lit

No main power to the amplifi er. Check AC power connections at the
amplifi er and the AC outlet. Check the front panel power switch. Make
sure that it is set to the ON position. If using 12V trigger power-on,
make sure that a trigger signal is present at rear panel 12V TRIG IN
jack.

No Sound

If the amp is getting AC power, but is producing no sound, check
2
the Protection Indicator on the front panel. If lit, see below. If
not, check all of your connections and control settings on associated
components. Make sure that your input connections and speaker
connections match your system confi guration.

Protection Indicator Is Lit

The front panel Protection Indicator
protection circuits have shut off the amplifi er. Typically, this occurs
only when the amplifi er has overheated, when there is faulty speaker
wiring, or after a period of extreme use. Turn off the system and wait
for the amplifi er to cool. Then push the front panel power switch in
and out to reset the protection devices. If the problem is not corrected
or reoccurs, there is a problem with the system or the amplifi er itself.
2
will light when the amplifi er
Specifi cations
Continuous Power Output Continuous Power Output
(20-20 kHz, < 0.03%, 8 ohms)
RB-1562
RB-1572
Total Harmonic Distortion Total Harmonic Distortion
(20Hz-20kHz, 8 ohms)
Intermodulation Distortion Intermodulation Distortion
(60 Hz : 7 kHz, 4 :1)
Frequency Response Frequency Response
(± 1 dB)
RB-1562
RB-1572
Damping Factor Damping Factor
(20 – 20 000 Hz, 8 ohms)
RB-1562
RB-1572
Speaker Impedance Speaker Impedance
Signal to Noise Ratio Signal to Noise Ratio
(IHF A network)
Input Impedance/Sensitivity Input Impedance/Sensitivity
RB-1562
RB-1572
Gain Gain
RB-1562
RB-1572
Power Requirements Power Requirements
U.S. Version
European Version
Power Consumption Power Consumption
RB-1562
RB-1572
Dimensions Dimensions
(W x H x D)
Front Panel Height Front Panel Height
Weight Weight
(net)
RB-1562
RB-1572
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
9
100 watts/canal
250 watts/canal
< 0.03 %
< 0.03 %
10 Hz – 40 kHz
10 Hz – 80 kHz
200
400
4 ohms minimum
109 dB
8.3 k ohms / 1.25V
8.3 k ohms / 1.5V
27.2 dB
27.1 dB
120 volts, 60 Hz
230 volts, 50 Hz
130 watts
280 watts
431 x 99 x 339 mm
3
17 x 4 x 13 / ins.
8
1
2U / 88.1 mm / 3 / ins.
2
5.6 kg / 12.35 lbs.
7.8 kg / 17.2 lbs