Installing/Removing The Belt Clip; Installing The Belt Clip; Removing The Belt Clip; Connecting The Earphones - Silvercrest PMR SPMR 8000 A1 Manual Del Usuario E Información De Servicio

Installing/removing the belt clip

Installing the belt clip

Insert the belt clip into the guide located at the handheld transceiver
back panel. The belt clip must click into place.

Removing the belt clip

To remove the belt clip from the handheld transceiver, pull the latch
on the belt clip [A] while sliding the belt clip out of the guide in the
direction of the antenna [B].

Connecting the earphones

You can use your PMR sets with the supplied earphones. The earphones receptacle [2] is located behind
a protective cover.
WARNING
Before connecting the earphones, you must reduce the sound volume (see page 108)
otherwise you risk damaging your hearing due to the high earphones level.
1. To connect the earphones, open the rubber cover that protects the earphones receptacle [2].
2. Insert the 2.5 mm jack-type earphones plug into the earphones receptacle [2].
3. Fasten the earphones cable to a piece of clothing by using the clip attached to the cable and then
insert the earpiece into your ear.
The PTT button on the earphones works in exactly the same way as the PTT button [11] of your PMR.
When using the PTT button of the earphones you must speak into the microphone located on the
earphones cable.
Do not connect any other headphones or earphones, otherwise you risk seriously
damaging your PMR.
When using the earphones, the IPX2 protection against vertically falling drops of
water with tilted enclosure is not guaranteed.
SilverCrest SPMR 8000 A1
(The figure is representational)
English - 107