T.I.P. MTS 30000 UV 24 INOX Instrucciones Para El Manejo página 17

4. Dismantle the UVC lamp. Take the lamp out of the compartment in the filter housing.
6.2.1. Cleaning of the quartz glass cylinder
1. Turn the UV-C radiator's ballast device (32) anticlockwise by 45°. Remove the UV-C lamp with the ballast
device from the holder carefully.
2. Replace the UV-C tubes (31) if necessary.
3. Then undo the four screws (26/30) on the quartz glass piston holder and pull the quartz glass and holder
out of the housing carefully.
4. Clean the quartz glass (28) and housing (25) thoroughly with water and a soft cloth.
5. If needed, remove lime scale from the quartz glass (28) with a suitable solvent. Rinse out thoroughly
before reassembling.
6. If quartz glass tube or O-rings are defective they must always be replaced
Fit everything in reverse order.
Do not screw the quartz glass piston holder tight to the UV-C radiator housing (25) with excessive force.
Ensure that the sealing ring (29) is inserted exactly into the groove on the protective quartz glass. Grease
the O-ring (29) with Vaseline if required.
6.2.2. Replacing the UV-C lamp
Attention! The UVC tubes must be placed by the manufacturer or their customer service, or by a similar
qualified person, to prevent hazards.
1. Always disconnect the power supply before performing any maintenance work.
2. Unscrew the socket with the lamp inside, remove the UV-C lamp and replace it with the new one.
Caution! Do not touch UV-C tubes directly with your hand; put on cotton gloves!
Do not dispose of old, broken UV-C tubes in the household waste. Consult your local disposal company.
Do not use any sharp-edged tools. If the quartz glass piston or O-rings are faulty, they must always be
replaced.
6.2.3. Function check of UVC lamp
Check the function of the UV-C-lamp by the bluish light on the bulb holder (1).
In case the UV-C-lamp does not shine, the UV-C lamp may not be properly assembled. Check this with the
above installation instructions.
6
15