Assembly - HAMPTON BAY EF200SQ-52 Guía De Uso Y Mantenimiento

Assembly - Hanging the Fan (continued)
2
Hanging the fan
WARNING: The hook (UU) is only to balance the fan while
making the electrical connections. Failure to hang as shown
may result in the hook (UU) breaking, causing the fan to fall.
The hook must pass from the inside to the outside of the
canopy.
WARNING: When hanging the fan on the hook (UU) it is
critical that you use one of the non-slotted (round) holes in
the canopy (C).
□
Carefully lift the fan-motor assembly (F) up to the slide-on
mounting bracket (A).
□
If using the downrod, insert the ball portion of the ball/
downrod assembly (B) into the socket of the slide-on
mounting bracket (A).
□
Turn the ball/downrod assembly (B) clockwise until it is
seated with the tab of the slide-on mounting bracket (A)
aligned with the slot in the ball.
□
If using close-to-ceiling mounting, hang the fan on the hook
provided by utilizing one of the holes at the outer rim of the
ceiling canopy (C).
UU
3
Wiring the fan to the receiver
WARNING: Remove the rubber motor stops on the bottom of the
fan before installing the blades or testing the motor.
IMPORTANT: Use the wire connecting nuts (CC) supplied with your
fan. Secure the connectors with electrical tape and ensure there
are no loose strands or connections.
NOTE: The fan comes with 54 in. lead wires for use with an
extended ball/downrod assembly. If using the 4.5 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your desired
length (no shorter than 12 in.).
□
The fan comes with 30 in. lead wires for use with an extended
ball/downrod assembly. If using the 4.5 in. ball/downrod
assembly (B) provided, you can cut the lead wires to your
desired length (no shorter than 12 in.) This will make extra
room in the canopy (C), if you do not wish to cut the wires,
you will need to neatly wrap them.
□
Connect the fan motor green wire(s) to the household green
or bare wire using a wire connecting nut (CC).
□
Connect the fan motor white wire to the household white wire
using a wire connecting nut (CC).
□
Connect the fan motor black and blue wires to the household
black wire using a wire connecting nut (CC).
□
Secure each wire connecting nut using electrical tape.
□
Turn the wire connecting nut (CC) upward and push the wiring
into the outlet box (NN).
A
C
Black
D
Blue
F
9
Please contact 1-855-HD-HAMPTON for further assistance.
Outlet box
in the ceiling
(NN)
Green or bare
White
Black Black Green
HAMPTONBAY.COM