System Controls - Buffalo filter ViroVac Manual Del Operador

2.1 System Controls

The electronic system controls on the ViroVac™ Smoke Evacuation System(s) are easy to under-
stand and simple to use. The membrane control panel contains the suction on/off switch, suction
power adjustment, filter life indicator, and service indicator light. See Figure 1.
Note: Please be sure to read all instructions before installing accessories or operating this equip-
ment. Failure to do so may result in damage to the unit and/or personal injury.
• SUCTION ON & Standby
There is one ON/OFF button on the ViroVac™ Smoke Evacuation System(s). The suction ON
switch on the electronic membrane control panel is located in the upper right hand corner of the
membrane panel. To power up the machine, (|), connect the supplied power cord to a grounded
outlet and the appliance inlet on the back of the smoke evacuation system. Once power has been
applied, the yellow standby LED will illuminate on the keypad. Press the ON/OFF button on the
membrane panel to illuminate the "fan running" green LED indicating active suction. Place the
unit in "standby" by pressing the suction ON membrane switch to illuminate yellow STANDBY
LED. Turn the system main power off, (O), by unplugging the power cord from the appliance
inlet on the unit or the receptacle in the wall.
• SUCTION CONTROL
(Membrane Control Panel)
The amount of suction may be adjusted by pressing the suction control button. Each time the suc-
tion control button is depressed, the motor speed in increased. Once the suction has reached the
maximum level, depressing the button again will return suction level to lowest setting. The suc-
tion control should be set at the lowest practical setting to completely remove the surgical smoke
from the operative site. Each time the arrow button is pressed, the suction will change to a differ-
ent flow setting (low / medium / high).
• FOOTSWITCH / EZ LINK REMOTE ACTIVATION DEVICE
(Membrane Control Panel)
The ViroVac™ Smoke Evacuation System also comes equipped with a pneumatic footswitch.
A footswitch or a EZ Link Remote Activation Device may be added to any system by simply
plugging in a BUFFALO FILTER activation accessory into the appropriate jack on the front of
the unit. When the footswitch is plugged in, the unit may be turned on or off by depressing the
footswitch pedal once for each operation. For directions on using the EZ Link Remote Activation
Device, please see instructions that accompany that product.
Operating Instructions
Section 2.0
Buffalo Filter ViroVac™ Operator's Manual: Page 10