Publicidad
Idiomas disponibles
Idiomas disponibles
39
1/4-20 x 2 3/4 Hex Head Bolt
(Qty. 1)
1/4-20 x3 1/2 Hex Head Bolt
(Qty. 2)
11. Attach end of linkages #4 with two holes to INSIDE of Leg #2 as shown in
Detail H & Detail I. Secure through end hole with screws #23, plastic
spacers #31and locknuts #15. Tighten hardware snug enough to keep
table stable but do not overtighten. Tubes must pivot freely.
12. On one side of the table attach slotted end of safety strap
#6 to INSIDE of Leg #2 using one bolt #39, one spacer
#30, one washer #24, and one Thin Locknut #35.
Tighten hardware until snug but do not overtighten. Tubes
must pivot freely. See Detail H.
13. Attach other end of safety strap #6 to OUTSIDE
of linkage #4 using one bolt #9, one washer
#24, one spacer #30, and one Locknut #15 as
shown in Detail H.
Important! Do NOT put other safety
strap #6 on this table half. It will be
installed on second table half later.
14. Tap caster sockets #12 into U-support #7
until flange on sockets touches the edge of
the tube. DO NOT HIT CASTER SOCKET
DIRECTLY WITH A HAMMER! SET A
PIECE OF WOOD ON CASTER SOCKET
AND HIT PIECE OF WOOD TO DRIVE
CASTER SOCKET INTO U-SUPPORT.
15. Insert one Caster without Lock #11
and one Caster with Lock #38 into
caster sockets #12. See Figure 8A.
1" Spacer
15
31
(Qty. 2)
1/4" Locknut
(Qty. 3)
30
4
2
30
39
23
9
24
Detail H
31
11
38
24
With Lock
5/16" Spacer
(Qty. 2)
9
First Table Top
Figure 8A
Figure 3
Figure 3
4
6
24
35
Thin
30
15
35
1/4" Thin
Locknut
Plastic Washer
1/16" Thick
(Qty. 1)
(Qty. 2)
1/4-20 x 1 1/2 Bolt
(Qty. 1)
4
4
15
31
Detail I
11
Without
Lock
12
7
2
23
Publicidad
