Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED TO
MOVE TABLE HALF!
20. Repeat steps from 1-13 on SECOND Table top half.
21. Tap caster sockets #12 into U-support #7 until flange on sockets
touches the edge of the tube. DO NOT HIT CASTER SOCKET
DIRECTLY WITH A HAMMER! SET A PIECE OF WOOD ON
CASTER SOCKET AND HIT PIECE OF WOOD TO DRIVE
CASTER SOCKET INTO U-SUPPORT.
22. Insert one Caster without Lock #11 and one Caster with
Lock #38 into caster sockets #12. See Figure 9.
23. Attach linkages #4 to the OUTSIDE of U-support
#7 on second table half. Use Bolts #14, 1/8"
thick Plastic Washers #36 and Lock nuts #15.
See Figure 9.
NOTE: Tighten locknuts #15 finger tight only.
They will be removed when the two
table top halves are connected.
With Lock
38
12
7
36
14
4
15
Second Table Top
Figure 9
Figure 3
Figure 3
13
Hardware Needed
36
15
Plastic Washer
1/4" Locknut
1/8" Thick
(Qty. 2)
(Qty. 2)
14
1/4-20 x 1 3/4 Bolt
(Qty. 2)
NOTE: Tighten locknuts #15 finger tight only.
They will be removed in the next step when
the two table top halves are connected.
11
Without
Lock
12
7
36
15
14
4
Publicidad
