Publicidad
Idiomas disponibles
Idiomas disponibles
Hardware Needed
#10-24 Lock Nut
16
(Qty. 2)
#10 Flat Washer
17
(Qty. 2)
#10-24 X 3/4 Round
10
Head Screw
(Qty. 2)
INSTALL SAFETY LATCHES #8 AS SHOWN FOR PROPER USE OF
TABLE! DO NOT SKIP THIS STEP! DO NOT OPERATE TABLE UNTIL
SAFETY LATCHES ARE INSTALLED AND ASSEMBLY IS COMPLETE!
31. Choose a name panel #5 on either side of the table and install one safety
latch #8 into the right-hand hole on that name panel as shown in Figures
11,12& Detail K. Use one screw #10 one washer #17 and one Locknut
#16. NOTE: Flange on safety latch must extend over top of name
panel as shown in Detail K and the "Top View". Safety latch must
pivot freely.
32. Go to the other side of the table and install the second safety latch into the
right-hand hole on the other name panel #5. NOTE: Safety latches must be
attached diagonally across from each other. See Figure 12.
Figure 3
Figure 11
Figure 3
CAUTION:
CAUTION:
Figure 3
Figure 12
Figure 3
16
5
8
10
17
Detail K
16
Publicidad
