Date Display; Weather Forecast Symbols; Manual Settings - TFA 35.1163.01 Instrucciones De Uso

TFA_No. 35.1163_Anleitung 28.08.2021
Wireless Weather Station
5.4 Note on radio-controlled time
• The time is transmitted from an atomic clock near Frankfurt am Main by a DCF-77 (77.5 kHz) frequency signal with a range
of about 1,500 km. Your radio-controlled clock receives the signal, converts it and always shows the exact time. The
adjustment of Daylight Saving Time and Standard Time is also automatic.
• During night-time, the atmospheric interference is usually less severe. A single daily reception is adequate to keep the
accuracy deviation under 1 second. In extreme cases, please place the unit close to a window to improve reception.
6. Operation
• The device will automatically quit the setting mode if no button is pressed for 15 seconds.
• Press and hold the UP/MAX/MIN or DOWN/RCC button in setting mode for fast mode.

6.1 Manual settings

• Press and hold the MODE button for two seconds to enter the setting mode.
• The first adjustable value flashes on the display.
• Use the UP/MAX/MIN or DOWN/RCC button to make the desired setting, while the value flashes.
• Confirm with the MODE button and go to the next setting.
• The sequence is shown as follows:
– Year, month, day
– Hours, minutes
– Time zone +12/-12 (default: ZONE 00)
– DCF reception ON/OFF (default: ON)
6.1.1 Time zone setting
• In the setting mode you can make the time zone correction +12/-12).
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
6.1.2 DCF reception
• By default, the DCF reception is activated (ON) and after successful reception of the DCF signal no manual time setting is
necessary.
• Once the DCF time reception is deactivated (OFF) the time and date must be manually set.
• If the DCF reception is activated, the manually set time will be overwritten by the DCF time when the signal is received suc-
cessfully.
20
9:18 Uhr Seite 11
Wireless Weather Station

6.2 Date display

• With the MODE button you can switch between the display of time and date. The sequence is shown as follows: time, year,
month, date. The display automatically switches back to the current time display.
7. Maximum and minimum temperatures
• The maximum and minimum outdoor and indoor temperatures since the last reset are permanently displayed.
• Press and hold the UP/MAX/MIN button for 3 seconds. All MAX/MIN values will be deleted and reset to the current state.
8. Forecast

8.1 Weather forecast symbols

• The weather station has 7 different weather symbols:
sunny slightly cloudy cloudy
• A snow crystal (symbol 6 and 7) is shown if rain or thunderstorm is forecasted and the outdoor temperature on channel 1
is under 0°C. If no transmitter is connected on channel 1, the device uses the values of channel 2 or 3. If this respective
transmitter is not situated outside or if there is no transmitter connected, there will be no snow forecast.
• The weather forecast relates to a range of 6 to 12 hours and indicates only a general weather trend. For example, if the cur-
rent weather is cloudy and the rain symbol is displayed, it does not mean the product is faulty because it is not raining. It
simply means that the air pressure has dropped and the weather is expected to get worse but not necessarily rain.
8.2 Trend arrows
• The trend arrows on the display will show whether the atmospheric pressure of the last 3 hours is increasing, steady or
decreasing.
Increase (+1-2 hPa) Weather improvement
Fast increase (>+2hPa) Significant weather improvement
rainy thunderstorm snowfall thunderstorm
(rain) (snow)
21