Extremis STICKS Manual Del Usuario página 7

FLOOR FASTENING
1. Begin by marking the centre of
the base and drill a ø6 mm hole
through the base.
4. Position the base making sure
that the hole in the middle of the
base is situated exactly above the
hole. Insert a screw (ø6mm, L:
80mm) in this hole and tighten it
as much as possible.
EXTRA WEIGHT FOR WINDY PLACES
2. Position the base where you want
to install your Sticks. Insert a pen
in the hole in the middle of the
base and mark the floor.
5. Insert the rods in the base.
TIP
: If possible, cover the screw
with a black cap.
In windy places, you can use an extra weight for the
60x30 and 30x30 bases and for the two curved bases.
When assembling, make sure that the holes in the extra
weight correspond to the holes in the base.
3. Drill a hole at the marked spot.
Insert a plug n° 8 in the hole.
6. When all the rods are in place,
the cap is not visible.
english 7