Introduction
The T30/T10 Spreading System 3.0 is compatible with the Agras T30/T10 aircraft respectively and offers efficient and
reliable spreading operations.
The spreading system comes up with a built-in stirring device and hopper gate control structure to prevent material
blockages and improve operating accuracy and reliability. The weight sensors monitor the weight of the remaining
material in the spread tank in real time while the control module improves the accuracy of the spread rate control and
empty tank warning. Fenders are included in the packaging and can block spreading material that flies upward from
damaging the propellers.
Users can configure spreading settings in the DJI Agras app and create specific templates for different materials in order
to meet different requirements. The app also provides warning prompts for an empty tank as well as for abnormalities in
rotational speed, temperature, and hopper outlet size.
In the Box
Spreading System 3.0 × 1 Spare Spinner Disk × 2
The T30 Spreading System and T10 Spreading System are similar in appearance, but the spread tanks are different
sizes. Unless otherwise specified, the illustrations in this document use the T30 Spreading System 3.0 as an example.
Overview
Weight Sensors
Installation
• Make sure to remove the Intelligent Flight Battery from the aircraft before installation.
• Operate with caution to avoid injury caused by sharp or moving mechanical parts.
Control Module
Cable
Fender Pair × 1
Fender Screw × 4
Spread Tank
Spreader Lock Knob
Spreader
Spinner Disk
Small Flow Hopper Gate
× 1
Stopper
(for T30 only)
(for T10 only)
© 2021 DJI All Rights Reserved.
3