DJI T30 Guia Del Usuario página 9

Usage
Creating Templates
There are templates for several typical spreading materials in the spreading settings in the DJI Agras app. In Route, A-B
Route, or Manual Plus operation mode, users can select the template according to the material used. If the performance
of the existing templates is unsatisfactory or other materials are being used, users can create a new template as follows:
1. Disassemble the spinner disk according to the instructions in the Maintenance section.
2. Make sure that the spreading system cable is connected and power on the remote controller and aircraft. Tap
the left of the screen in Operation View in the app to enter Spreading Settings.
3. Tap the dropdown menu for templates and then New Template.
4. Tap Flow Calibration and set the type of the hopper outlet in use. Tap Start Calibration and follow the prompts to
complete calibration.
When using the standard hopper gate that has been mounted to the spreading system before delivery, set
the hopper outlet type to Hopper Outlet 1. When using the small flow hopper gate, set the hopper outlet
type to Hopper Outlet 2. Refer to the Small Flow Hopper Gate Product Information for installation.
5. Set the material amount, spinner disk speed, and flight speed. Tap Save.
6. Power off the aircraft and remount the spinner disk.
Spreading Operations
1. Power on the remote controller and then the aircraft. Enter Operation View in the DJI Agras app.
2. Open the cover, add compatible material, and close the cover. The DJI Agras app will intelligently recommend the
payload weight limit for the spread tank according to the current status and surroundings of the aircraft. Do not
exceed the recommended payload weight limit when adding material to the tank. Otherwise, the flight safety may be
affected.
3. Select the operation mode or use a planned field.
4. Tap on the left of the screen to enter Spreading Settings.
5. In Route, A-B Route, or Manual Plus operation mode, select a template for the spreading material and set parameters
such as the material amount, spinner disk speed, flight speed, line spacing, and height relative to the vegetation. In
Manual operation mode, set the hopper outlet size and spinner disk speed. Adjustable parameters vary depending
on the operation mode. It is recommended to adjust the settings so that they are suitable for the materials you are
using and perform a test to make sure the performance is as expected.
It is recommended to do the following when spreading 45 kg/ha of materials in Manual operation mode.
• Adjust the hopper outlet size so that the material delivery rate is 8 kg/min.
• Adjust the spinner disk rotational speed so that the spreading range is 5 to 7 meters.
• Maintain a flight speed of approximately 5 m/s.
6. Start the operation. The operations of the spreading system vary depending on the operation mode.
Route Operation Mode
After starting an operation, the aircraft ascends to a preset takeoff altitude and the spinner disk spins. When the aircraft
reaches the starting point of the route, the hopper gate opens and the aircraft flies along the route and spreads material
automatically. Spreading cannot be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is paused, the hopper gate closes
automatically to stop spreading while the spinner disk is still spinning. After the operation is resumed, the aircraft returns
to the breakpoint or projection point and continues spreading.
© 2021 DJI All Rights Reserved.
8
on