Brandt Four Manual De Instrucciones página 26

EN 1 / INFORMATION FOR THE USER
away unless they are supervised at all
times.
— This appliance is designed to cook
with the door closed.
— Before pyrolytic cleaning of your
oven, remove all accessories and any
thick deposits.
— During cleaning, the surfaces may
become warmer than under normal
conditions of use. It is advisable to
keep children away from the appliance.
— Do not use a steam cleaner.
— Before removing the back wall, the
appliance must be powered off. After
cleaning, the back wall must be put
back in place in accordance with the
instructions.
— Do not use abrasive cleaning
products or hard metal scrapers for
cleaning the oven's glass door, as they
could scratch the surface and cause
the glass to shatter.
WARNING: Make
appliance is disconnected from
the power before replacing the lamp in
order to avoid the risk of electric shock.
Change the lamp only when the
appliance has cooled down. To unscrew
the view port and the light, use a rubber
glove, which will make disassembly
easier.
The electrical plug must remain
accessible after installation. It
must be possible to disconnect the
appliance from the power supply, either
using a plug or by fitting a switch on the
fixed wiring system in accordance with
installation rules.
If the power cable is damaged, it should
be replaced by the manufacturer, its
after-sales service department or by a
similarly qualified person in order to
avoid danger.
— This appliance may be installed
either under a worktop or in a cabinet
column, as indicated on the installation
diagram.
— Centre the oven in the unit so as to
ensure a minimum distance of 10 mm
between the appliance and the
surrounding unit. The material of the
unit supporting the appliance must be
heat-resistant (or covered with a heat-
resistant material). For greater stability,
attach the oven to the unit with
2 screws through the holes provided on
the side panels.
sure the
EN-6