Misfeed Removal - Olivetti d-Copia 12 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 75
4. Set the charger cleaner onto the right end of the
transfer charger, gently slide the cleaner to the left
end, and then remove it. Repeat this operation two or
three times.
Slide the charger cleaner from the right end to the
left end along the groove of the transfer charger. If
the cleaner is stopped on the way, smudges on
copies may occur.
5. Return the charger cleaner to its original position.
Close the side cover by pressing the round projections
near the side cover open button.
6. Turn the power switch on.
GB-14
All manuals and user guides at all-guides.com

MISFEED REMOVAL

When the misfeed (
) indicator blinks or
t
the display, the copier will stop because of a misfeed.
1. Open the side cover whilst pressing the side cover
open button.
2. Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illu-
Q
stration below. If
blinks in the display, proceed to
"A Misfeed in the paper feed area".
1 If the misfed paper is seen from this side, proceed
to "C Misfeed in the transport area". (p. GB-15)
2 If paper is misfed here, proceed to "B Misfeed in the
fusing area". (p. GB-15)
3 If paper is misfed here, proceed to "A Misfeed in the
paper feed area".
1
A. Misfeed in the paper feed area
1. Gently remove the misfed paper from the paper feed
area as shown in the illustration.
Q
When
blinks in the display and the misfed paper is
not seen from the paper feed area, pull out the paper
tray and remove the misfed paper.
The fusing unit is hot. Do not touch the fusing unit
when removing misfed paper.
Q
blinks in
2
3

Publicidad

Tabla de contenido
loading

Tabla de contenido