Use And Operation - Klarstein 10028629 Manual Del Usuario

• Never open rear panel of dehydrator. Never remove back screen from dehydrator.
• If extension cord is used be sure the marked electrical rating is at least as great as the electrical rating of this
appliance.
• Be sure dehydrator is stable during use. All four feet should be secure on a level surface. Dehydrator should
not move during operation.
• Do not operate dehydrator outdoors or near any flammable or combustible materials. Indoor use only. Not
for commercial use.
• Use in a well ventilated location. Do not block air vents on door or at rear of dehydrator. Keep dehydrator at
least (30.5 cm) away from any wall to allow for proper air circulation.
• Do not operate dehydrator on flammable surfaces such as carpeting, etc.
• To prevent electric shock. Do not immerse unit and control panel in water or liquid. Serious injury from elec-
tric shock could result. Do not use appliance with wet hands or bare feet. Do not operate near running water.
• Disconnect from power outlet before cleaning components. Read all instructions before cleaning dehyd-
rator.
• After cleaning, make sure dehydrator is completely dry before reconnecting to the power outlet - if not;
electric shock may result.
• Do not place or use the unit or any parts on or near hot gas or electric burner, in a heated oven, or on stove
top. Do not let power cord hang over edge of table or counter or touch any hot surfaces.
• Do not use appliance for other than intended use.
• Lf appliance malfunctions during use, shut down unit immediately and discontinue use. Do not attempt to
open control panel. This product has no user-serviceable parts. Always contact authorized service centre if
unit malfunctions or for service. Do not use or replace with any unauthorized parts not intended for this unit.
All parts for this appliance must be used according to Instruction Manual. ONLY use manufacturer approved
parts from authorized Service Center. Any other parts or accessories not intended for use with this appl
lance is strictly prohibited and will void warranty.
Functional buttons
For time setting.
For temperature setting.
Getting Started
Connect electricity, the LCD display shows
and displays . Press
be 1 hour added Press and hold regular time to fast forward Time setting range 0-36 hours cycle selection
available After time setting after 3 seconds, it starts working.
After time setting, product starts working. Default temperature stall is 55°C. LCD shows
ternately. means remaining time and
perature as you required while it' s working. Press
there would be 5°C increased. Press and hold regular time to fast forward.
All manuals and user guides at all-guides.com

Use and Operation

. Then press
, button to set working time as you required, each pressing there would
means working temperature stall You could adjust the tem-
then into time setting LCD twinkling
to set temperature as you required. Each pressing,
and al-
8