Service; Introduction; Split Design - Titan MAXUM ELITE Manual Del Propietário

Service

Should your HVLP spray gun need service during the warranty
period, return the unit and the proof of purchase to the distributor
where it was purchased. At our option, the unit will be repaired
or replaced. In a continued commitment to improve quality, we
reserve the right to make component or design changes when
necessary.

Introduction

These spray guns are designed for use in a High Volume/Low
Pressure (HVLP) painting system.
With an HVLP system, the highest quality professional finish can
be achieved with little preparation or setup time. HVLP systems
are not intended to replace airless systems. Instead, they are
meant to compliment airless by improving the final finish on the
substrate, minimizing waste, and reducing labor time. In addition
to enhancing profitability, HVLP systems are compliant with the
most stringent transfer efficiency requirements.
The HVLP spray guns described in this manual include the
turbine cup gun and the turbine top feed gun. Please review
all the information contained in this manual before operating an
HVLP system.
NOTE: The general operation and maintenance of each
style of hvLP spray gun are the same. For
illustration purposes, the turbine cup gun is
pictured. However, any information specific to
a style of gun is described where necessary. a
parts listing for each style of gun is included near
the back of this manual.
Air flow
adj. knob
Material flow
adj. knob
Trigger
release
Packing nut
Trigger
Check valve
Air Inlet
NOTE: The hook on top of the gun body can be easily
removed or reversed. Slide the hook toward the
rear of the gun to remove it.
© Titan Tool Inc. All rights reserved.

Split Design

This HVLP spray gun has a split-gun design that allows for easier
cleaning and disassembly. The two sections are the gun head
and gun rear.
Gun rear
To separate the two halves of the HVLP spray gun, follow the
steps below.
1. Make sure the air hose is removed from the air inlet of the
spray gun.
2. Swivel the trigger releases on
both sides of the spray gun so
they are pointing up.
3. Push the lever toward the rear
of the gun to unlock the two
gun halves.
4. While looking at the rear of the
spray gun, turn the gun rear counterclockwise to remove it
from the gun head.
Hook
Lever
Air cap ring
Air cap
Fluid inlet
Cup locking
lever
NOTE: The needle will remain inside the gun head. Be
sure not to remove unless instructed.
1-Quart cup
assembly
To join the two halves of the HVLP spray gun, follow the steps
below.
1. Make sure the trigger releases on both sides of the spray
gun are pointing up (toward the gun hook).
2. With the gun rear oriented upside down, bring the two
Swivel tube
halves together. While looking at the rear of the spray
lever
gun, turn the trigger section clockwise until it snaps back
into place with the gun head.
3. Swivel the trigger releases on both sides of the spray gun
so that they are pointing toward the gun head.
3
Gun head
Needle
English